Orient the stainless steel rear brace horizontally and slide into the 2nd grill slot from the top.
Repeat for the other side.
Note: The top collar stop (A) will prevent the stainless steel brace from coming loose and falling
behind the grill.
Align stainless steel rear brace vertically and insert bolt (lock washer first, then flat washer) through the bottom hole in the mount. Hand-start the stainless steel bolt into the threaded stainless steel rear brace. Check for center alignment of mount, tighten 4 bolts using provided hex key, and secure mount until lock
washer is flat.
Please do not over-torque!
Removal procedure: loosen and remove the bottom bolt first. Loosen the top bolt.
Secure license plate (with or without license plate frame) to the mount using a Phillips screwdriver and the 4 x 3/8” screws provided.